• Registered: 2011-05-04
  • Posts: 1

Topic: Aspen platform Error DCI-06CA, DCI-06C4

Hello! At loading Acuson Aspen at testing the device shows errors DCI-06CA, DCI-06C4
It is thankful in advance, mister Gavrilov (Abakan, Russia)

  • Todd
  • Administrator
  • Offline
  • From: Oceanside, CA
  • Registered: 2009-02-05
  • Posts: 297

Re: Aspen platform Error DCI-06CA, DCI-06C4

06CA and 06C4 usually refer to a communications error with the hard drive. Possible causes are: MO Drive, Hard Drive, SCSI cables from disk bay to scan converter, DCI (Digital Compression Interface) circuit board.

What revision level is your system at? If you need help finding this, please refer to this post on the forums: CSR Menu

Whenever I have those two errors it's usually fixed by reloading system software, or replacing the hard drive with another that has a fresh install of system software. On boot-up, does the system display an "AEGIS NOT RESPONDING" message after a while?

Universal Diagnostic Solutions

Todd's Website

  • LUIS
  • New member
  • Offline
  • Registered: 2012-02-24
  • Posts: 1

Re: Aspen platform Error DCI-06CA, DCI-06C4

I have the same problem, my software rev is 7.03 and it does send a message a minute after initianting that says: "Aegis is not responding, continue without aegis?", I click continue and it works normal, of course without aegis. What do you think?

  • Todd
  • Administrator
  • Offline
  • From: Oceanside, CA
  • Registered: 2009-02-05
  • Posts: 297

Re: Aspen platform Error DCI-06CA, DCI-06C4

Chances are it's a dead hard disk, or you may need a software reload.

Universal Diagnostic Solutions

Todd's Website